INDUSTRY

Aerospace & UAV

Cable supports and airframe clips in PEI and PEEK, molded under aerospace-grade discipline.

THE CHALLENGE

Why this application is a material problem

Cable supports and airframe fittings need high strength, high insulation, flame resistance and low weight, and the material has to be flown, not just molded. PEI has become the standard for cable-support components; PEEK covers the higher-temperature positions.

Discuss Your Part

Typical parts we mold

Cable supports and clamps
Airframe clips and brackets
Sensor housings
Interior structural parts

Materials we work in

PEI, PEEK, PPS

What you get

Documented material certificates, dimensional reports, and a small-batch rapid-tooling route for flight-test quantities.

OTHER INDUSTRIES

Where else we work

Humanoid Robots

Joint frames, gears and bearing cages in PEEK — the material that makes weight reduction possible.

Medical Devices

Sterilization-resistant, biocompatible parts in PEEK and PPSU, with medical-grade sourcing and documented quality.

New-Energy Vehicles

High-voltage connectors, sensor brackets and battery-system parts in PPS, PPA and PEEK.

Have a 3D drawing? DFM feedback and quotation in 48 hours.

Send STEP / UG / STP files by email or WeChat — you get material analysis, gating proposal, cycle estimate and mold price in one reply.

Request a Quote

Specialty engineering plastics only — PEEK, PEI, PPS, PPSU, PSU, PES, LCP
Barrel 360–400 °C, mold 160–220 °C — built for PEEK's 343 °C melt
Rapid tooling delivers first samples in 7–15 days, 1–5,000 pcs
Moldflow first, first-article FAI report, key dimensions CPK ≥ 1.33